XL Lawn Tractor Service Manual 3 - 15
XL HYDROSTATIC TRANSAXLES
9. Install the belt around the flat idler pulley
assembly with the belt guide and tighten the bolt
and nut (Figure 115).
Figure 115
mvc-0010
10. Reconnect the idler spring to the idler bracket
(Figure 116).
Figure 116
mvc-001c
11. Adjust and tighten both the right and left engine
belt guides. They should be adjusted so they are
within 1/8” (3mm) of the engine pulley (Figure
117).
Figure 117
mvc-001b
12. Adjust and tighten both the right and left transaxle
belt guides. Make sure they are adjusted to within
1/8” (3mm) of the transaxle pulley (Figure 118).
Figure 118
mvc-0039
1/8” (3mm)
1/8” (3mm)
To Next Page
Loading...
