XL Lawn Tractor Service Manual 3 - 19
XL HYDROSTATIC TRANSAXLES
3. Reconnect the speed control link and the speed
control rod with washers and hairpins (Figure
131).
Figure 131
MVC-0015
4. Install the drive belt around the transaxle pulley
and around the engine pulley. Reconnect the idler
spring to the idler bracket assembly (Figure 132).
Figure 132
MVC-001C
5. Adjust and tighten both the right and left engine
belt guides. They should be adjusted so they are
within 1/8” (3mm) of the engine pulley (Figure
133).
Figure 133
MVC-001F
6. Adjust and tighten the transaxle belt guide. Make
sure it is adjusted so it is within 1/8” (3mm) of the
transaxle pulley (Figure 134).
Figure 134
MVC-0016
1/8” (3mm)
1/8” (3mm)
To Next Page
Loading...
