Toro XL Series - Page 61

XL HYDROSTATIC TRANSAXLES
3 - 24 XL Lawn Tractor Service Manual
9. Continue feeding the belt back up over the idler
pivot bracket and around the transaxle drive pulley
(Figure 148).
Figure 148
MVC-0022
10. Install the belt around the flat idler pulley
assembly with the belt guide and tighten the bolt
and nut (Figure 149).
Figure 149
MVC-0010
11. Reconnect the idler spring to the idler bracket
(Figure 150).
Figure 150
MVC-001c
12. On the other side of the idler pivot, is a V-idler
pulley. Install the V-section of the belt around the
pulley and adjust the pulley up to the two belt
guides located on the tractor frame. Adjust the
pulley so there is 1/8” (3mm) gap between the
pulley and belt guides (Figure 151).
Figure 151
MVC-0020
1/8” (3mm)