Toro Z Master 74941CP - Page 56

1
g017029
Figure88
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.Ifthedeck
istoohigh,loosenthesinglepointadjustmentbolt
byrotatingitcounterclockwise(
Figure89).
Note:Loosenortightenthesinglepointadjustment
boltenoughtomovetheheight-of-cutplate
mountingboltsatleast1/3thelengthoftheavailable
travelintheirslots.Thiswillregainsomeupand
downadjustmentoneachofthefourdecklinks.
g017036
Figure89
1.Singlepointadjustmentbolt
14.Tightenthetwoboltsatthebottomoftheheightof
cutplate(Figure88).Torqueto27-33ft-lb(37-45
N-m).
Note:Inmostconditions,thebackbladetipshould
beadjusted1/4inch(6.4mm)higherthanthefront.
15.Onbothsidesofthedeck,measurefromthelevel
surfacetothebacktipoftheblade(PositionB).The
measurementshouldread31/4inches(8.3cm)
(
Figure86).
16.Fine-tunetheadjustmentnutonthefrontdecklift
assemblybyturningit(
Figure87).
Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turncounterclockwise.
17.Measureuntilallfoursidesarethecorrectheight.
Tightenallthejamnutsonthedeckliftarm
assemblies.
18.Lowerdischargechute.
56