Toro Z255 - Greasing the Bearings

Maintenance
46
Where to Add Grease
Lubricate the grease fittings as shown on the CHECK
SERVICE REFERENCE AID decal (Fig. 33).
Figure 33
Where to Add Light Oil or Spray
Lubrication
Lubricate the machine in the following areas with
spray type lubricant or light oil.
• Seat switch actuator.
• Brake handle pivot.
• Brake rod bushings.
• Motion control bronze bushings.
Greasing the Bearings
The cutting unit must be lubricated daily. Refer to the
Service Interval Chart on page 35. Grease with No. 2
general purpose lithium base or molybdenum base
grease.
IMPORTANT: Make sure cutting unit
spindles ar e full of grease daily.
1. Stop the engine, set the parking brake, remove
the key and disconnect the spark plug wire(s)
from the spark plug(s).
2. Grease the fittings on the three spindle bearings
until grease comes out lower seals (Fig. 34).
3. Grease the fittings on the push arms(Fig. 34).
m–3890
Figure 34