Torso Electronics T-1 - ADJUSTING THE NOTE LENGTH USING SUSTAIN

81
The T-1 Notebook : Reference & Guide
80
The T-1 Notebook : Reference & Guide
NOTESNOTES
▌ ADJUSTING THE NOTE LENGTH USING SUSTAIN
1. Select the pattern and track.
2. To view the current note length Hold (SUSTAIN). Also double Press
(SUSTAIN) to lock the view. The value buttons will be lit to indicate the
current note length. Default is 50% indicated by the top row of 8
buttons.
3. The length will be applied to all notes and repeats. Any new notes
triggered before the prior note ends will cut off the previous note. The %
is applied with respect to the division setting.
4. To change the length value either:-
• Turn (SUSTAIN). This will adjust the value but is useful when
adjusting length by ear.
• Hold and Turn (SUSTAIN). This will make granular changes with the
value displayed on the value button brightness.
• While the value buttons are showing the sustain state, press one of
the [VB1] - [VB16] buttons. This is the best method for specic
changes where [VB16] represents 100% and [VB8] 50%.
The sustain value for note length visualisation is shown by the number of lit
value buttons and their brightness level. Turning (SUSTAIN) adjusts at a
granular level while the value buttons can make specic percentage
change. Hold or double tap (SUSTAIN) to see the value button status for
note length. Percentages shown are guides only.
Sustain View Mode.
Sustain View
Hold (SUSTAIN). Double tap (SUSTAIN)
to retain the value button display.
BLUE GREY ⬛
Note Length %
Brightness will reect granular % level adjusted
by holding and turning the (SUSTAIN) knob.
OFF
18
68
31
81
38
87
44
93
12
6256
25
75
50
100
3 Pulses (Division 1/16
th
)
3 Pulses (Division 1/16
th
)
1 Pulse (Division 1/16
th
)
16 Step Pattern
16 Step Pattern
16 Step Pattern
Examples: Sustain Note Length with respect to Division
Sustain (19% is approx 1/4 Division)
Sustain (50% is 1x Division)
Sustain (100% is 16 x Division)
1
1
1
5
5
5
9
9
9
13
13
13
Rhythmic Variation
4
Rhythmic Variation
4