EasyManuals Logo

Toshiba 32V35KP User Manual

Toshiba 32V35KP
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
5
Getting started
Installing the Stand or Wall mount bracket
Accessories List
Screws:
(M4×25) × 4
NOTE
The accessories may be different from the list above due to different
models, countries/regions, please refer to the actual accessory bag.
Base stand
The following accessories are included with TV:
OWNER’S MANUAL × 1 Remote Control × 1
Base Stand × 2 Screw × 4
AAA Battery × 2
Optional, some countries/regions may not have: P-Clip × 1(with 1 screw
M6×12 and 1 screw ST4×25C)
Installing the Stand
CAUTION
Be sure to disconnect the A/C power cord before installing a stand or
Wall-Mount brackets.
The LED display is very fragile, and must be protected at all times
when installing the base stand. Be sure that no hard or sharp object,
or anything that could scratch or damage the LED display, comes into
contact with it. DO NOT exert pressure on the front of the TV at any
time because the screen could crack.
After the installation is complete, make sure the TV is steady on a table
or firmly attached to a wall mount, before removing all protective film,
if any.
1. Carefully place your TV face-down on a soft, flat surface to prevent
damage to the TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert the
stands into the bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory tightly.
Wall mount hole pattern (mm)
100 × 200 (32")
200 × 200 (43")
Wall mount screw size (mm) M6
9.5 - 11.5 mm
Wall Mount Bracket
Wall Mount Screw
Wall Mount Spacer
Rear cover of the TV
Follow instructions provided with the wall mount bracket.
NOTES
The diameter and length of the screws differ depending on the wall
mount bracket model.
Wall mount bracket is optional, your device may not have wall mount
bracket, please refer to the actual accessories.
Installing the Wall Mount Bracket
Before mounting the TV, remove the TV stand if you have already attached it,
and make sure the wall mount bracket supports the weight of your TV.
When mounting the TV on a wall, follow instructions provided with the wall
mount bracket. If it is not correctly mounted, the TV may fall and cause property
damage or personal injury.
Place spacers between the TV and bracket.
Make sure the tilt angle between the TV screen and the vertical surface is
no more than 15 degrees.
Standard dimensions are shown below.
CAUTION
≤15°
TV screen
Vertical
surface

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba 32V35KP and is the answer not in the manual?

Toshiba 32V35KP Specifications

General IconGeneral
Screen Size32 inches
Resolution1366 x 768
Display TypeLCD
HDMI Ports2
USB Ports1
Smart TVYes
Aspect Ratio16:9
Refresh Rate60 Hz
Power Consumption50W
Built-in TunerYes

Related product manuals