• After selecting search type as Satellite, you can set
the desired options and press OK button to search.
In satellite manual scan, you can enter frequency,
polarisation, symbol rate values and change network
channel scan and satellite options by using left/right
buttons or numeric buttons on the remote. You can
then press OK button to search. If you enter invalid
manual tune settings a warning massage is displayed
on the screen.
Note: Frequency, polarization and symbol rate may
change in accordance with the selected channels.
Analogue Fine Tune
Only if an analogue signal or Service is available.
• Select Analogue Fine Tune from the Install and
Retune menu by using Up or Down and OK
buttons. Analogue ne tune screen will be displayed.
Analogue Fine Tune feature will not be available if
there are no analogue channels stored.
• Use Left or Right button to set Fine Tune. When
nished, press OK button.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
• Select Clear Service List from the Install and
Retune menu by using Up or Down and OK buttons.
A conrmation message will be displayed. If you
want to delete all channels, select Yes and press
OK. Use this setting to clear channels stored.
Manual Tuning, Analogue Fine Tuning - continued
The television can be tuned-in manually using Manual Search feature.
To Next Page
Loading...
Need help?
General