50
CONTROLS AND FEATURES
English
System Information and Reset TV
This feature can be used to check the version of software
currently installed. When in DTV mode, it includes additional
diagnostic information such as signal strength, signal quality,
centre frequency, modulation, etc.
a In the SETUP menu, press B or b to select System
Information.
b Press OK to display the System Information.
c For information about the signal quality of a particular
multiplex, press
B or b to select that multiplex.
d Press OK for a screen showing detailed technical
information about the selected multiplex.
Selecting Reset TV will reset all TV settings, including saved
channels, to their original factory values.
a In the SETUP menu, press B or b to select Reset TV.
b Press OK to select. A screen will appear warning that
all settings will be lost. Press OK to continue.
When the set powers back on, the Quick Setup
screen will appear. Press OK to advance the setup and
perform an auto tune. (See “Quick Setup” section on
page 13.)
PC Settings
Connect the PC (as shown in the ‘Connecting a computer’
section) and ensure that a picture is showing on the television
screen. The picture position may now be adjusted to suit
personal preference.
a Press MENU / Cc to highlight PREFERENCES icon.
b Press B or b to select Display Settings and press OK.
c Press B or b to select PC Setting and press OK.
d Press B or b to select an option and press C or c to
adjust the settings.
The Clock Phase matches the PC signal with the LCD display.
Adjusting this can clear horizontal stripes and picture blur.
a In the Display Settings menu, press B or b to select
PC Settings and press OK.
b Press B or b to select Clock Phase.
c Press C or c to adjust until the picture clears.
System Information
Reset TV
To Next Page
Loading...
