Selectingthe menulanguage
You can choose from three different languages (English,
French and Spanish) for the on-screen display of menus and
messages.
To select the menu language:
MENU
Press © and open the Preferences menu.
2 Highlight Nenu Languageand press _.
3 Press A or Y to select your preferred menu language
and press @.
CC Selector
Base CO Mode Off
Digital CO Settings
Input Labeling
4 Pr SS EXIT ,
e_ © to close the Preferences menu.
TOSHIBALogoLED
You can select TOSHIBALogoLEOeither Onor Off.
MENU
Press o and open the Setupmenu.
2 Highlight LogoLEDand press _.
3 Press A or Y to select either On or Off and press @.
Installation
Configuringthe antenna input
source for the ANT/CABLEterminal
To configure the ANT/CABLE input source:
1 Press M_Uand open the Setup menu.
2 Highlight Installationand press @.
3 (A new set of Installationmenu icons will appear, as
shown below.) Open the Terrestrial menu, highlight input
Configuration,and press @.
4 Press 4 or _ to select the input source (CabJe or
Antenna) for the ANT/CABLEinput on the TV.
5 To save your new settings, highlight [}oneand press @.
To revert to your original settings, highlight Cancel and
press @.
30
To Next Page
Loading...
