volatile compounds such as insecticide on the
TV
surface. Such products may damage
or
discolor the
TV.
38)
Never hit, press, or place anything on the back cover.
These actions will damage internal parts.
39)
~
WARNING:
Ji\
Lh
RISK
OF
ELECTRIC
SHOCK!
ill
Never spill liquids
or
push objects
of
any kind into the
TV
cabinet slots.
40)
During a lightning storm,
do
not touch the connecting
cables or
TV
set.
41)
For added protection of your
TV
from lightning and power
surges, always unplug the power cord and disconnect
the antenna from the
TV
ifyou leavethe
TV
unattended
or
unused for long periods
of
time.
42)
ALWAYS unplug the
TV
to completely disconnect from
main power. When the
TV
is
turned off using the on/off
switch, it
is
not completely disconnected from power and
a minute amount
of
current is still consumed.
43)
During normal use, the
TV
may make occasional
snapping or popping sounds. This
is
normal, especially
when the unit
is
being turned on or off.
If
these sounds
become frequent or continuous, unplug the power cord
and contact a Toshiba Authorized Service Provider.
44)
Lh
WARNING: RISK OF
SERIOUS PERSONAL
~
INJURY OR EQUIPMENT
DAMAGE!
Never strike the screen with a sharp
or
heavy object.
45)
• The LCD screen
of
this product can be damaged by
ultraviolet radiation from the sun. When selecting a
location for the television, avoid locations where the
screen may be exposed to direct sunlight, such as
in
front
of
a window.
• Never touch, press, or place anything on the LCD
screen. These actions will damage the LCD screen. If
you need
to
clean the LCD screen, follow the
instructions in item 37 on
p.
4.
Service
46)
~
WARNING:
Ji\
Lh
RISK
OF
ELECTRIC
SHOCK!
ill
Never attempt
to
service the
TV
yourself. Opening and
removing the covers may expose you
to
dangerous
voltage or other hazards. Failure
to
follow this
WARNING may result in death or serious injury. Refer all
servicing not specified
in
this manual
to
a Toshiba
Authorized Service Provider.
-------
47)
If you have the
TV
serviced:
• Ask the service technician
to
use only replacement
parts specified by the manufacturer.
• Upon completion
of
service, ask the service
technician
to
perform routine safety checks
to
determine that the
lV
is in safe operating condition.
Choosing
a
location
for
your
LCD
TV
To
Display
your
LCD
TV
on
the
included
Pedestal
Stand:
Observe the following safety precautions:
1)
Read and Follow the pedestal assembly instructions
included with the pedestal.
CAUTION: Before beginning pedestal assembly,
carefully lay the front
of
the LCD Panel face
down
on a
flat, cushioned surface such as a quilt
or
blanket.
Leave the bottom
of
the unit protruding over the edge
of
the surface and assemble the pedestal as indicated
below.
Note:
Extreme care should always be used when
attaching the pedestal stand
to
avoid damage
to
the
LCD panel.
2)
Place the
TV
on a sturdy, level surface
that
can support
the weight of the
lV.
3)
Be sure
to
secure the
lV
to
a wall stud, pillar, surface,
or other immovable structure. To secure the
TV
in
this
manner:
(1)
attach the provided securement clip
to
an
immovable structure, then
(2)
pass a sturdy strap
through the securement clip and attach each end
to
the hooks located on the back
of
the
TV.
Be sure
to
leave at least 4 inches between the
lV
and the wall
or
similar structure for ventilation. See item 26,
p.
4 for
additional details.
To
Display
your
LCD
TV
using
a
Wall
Bracket:
If you decide
to
wall mount your LCD
TV,
always use a
UL
Listed wall bracket appropriate
for
the size and weight
of
the LCD
lV
(1& p.
2)
:
CAUTION:
1.
Two
people are required for installation.
2.
To install a wall-mount from another manufacturer, use
the enclosed SPACERS. (Except 32")
1)
Unplug and remove any cables
and/or
other
component
connectors from the rear
of
the TV.
2)
Carefully lay the front
of
the unit face
down
on a flat,
cushioned surface such as a quilt
or
blanket.
3)
Follow the instructions provided with your wall
bracket. Before proceeding, make sure the
appropriate bracket(s) are attached
to
the wall and the
back
of
the
lV
as described
in
the instructions
provided with the wall bracket.
4)
Make sure
to
place the spacers provided with the
lV
between the bracket and the back
of
the
lV.
5)
Always use the screws supplied
or
recommended by
the wall mount manufacturer.
5
To Next Page
Loading...
