To Next PageTo Next Page
Need help?Do you have a question about the Toshiba 46TL868G and is the answer not in the manual?
General| Screen Size | 46 inches |
|---|---|
| Display Type | LED |
| HDMI Ports | 4 |
| USB Ports | 2 |
| Wi-Fi | Yes |
| Smart TV | Yes |
| 3D | Yes |
| Ethernet Port | Yes |
| Operating System | Toshiba Places |
| Resolution | 1920 x 1080 (Full HD) |
| Refresh Rate | 200 Hz AMR (Active Motion Rate) |
Records changes and amendments made to the service manual.
Legal disclaimer regarding modification or alteration of provided information and data.
Crucial warning about using lead-based solder for repairs on this product.
Necessary precautions to be observed before servicing the chassis.
Details regarding the measuring network for touch currents.
Highlights special safety characteristics of electrical and mechanical parts.
Provides crucial safety guidelines for handling the LCD module and its components.
Indicates that troubleshooting information is not yet available.
Accessing and navigating the TV's service mode for adjustments.
Instructions on how to switch the adjustment menu on or off.
Explains the functions assigned to specific buttons within the service mode.
How to cycle through adjustment items using the remote control or TV panel buttons.
Procedure for changing data values within the adjustment menu using volume buttons.
Method to exit the service mode by turning off the TV.
How to change built-in test patterns using the remote control.
Explains the meaning of different LED states during software upgrade.
A comprehensive list of adjustable items within the service mode.
Table for converting binary bit values to hexadecimal format for data conversion.
How to access and interpret the Self Check screen for system information.
Procedures for main PCB initialization and model ID installation.
Information on identifying the panel vendor based on markings and codes.
Overview of hotel mode, allowing customized TV operations for hotel use.
Procedure to access and navigate the hotel mode settings menu.
Detailed table of hotel mode options, descriptions, factory settings, and gray-out conditions.
Functionality for copying settings between TVs using the hotel clone menu.
Steps to save TV settings to a USB drive via the hotel clone menu.
Procedure to load TV settings from a USB drive using the hotel clone menu.
Instructions for performing a TV software upgrade using a USB device from the boot-up sequence.
Important warnings and cautions regarding part replacement and safety.
List of common abbreviations used for electronic components like capacitors and resistors.
Log of revisions and amendments made by DS Company.
Detailed list of parts with their location, part number, and description.
Identifier for the main schematic diagram of the PE1000ZA board.
Schematic section detailing the Mstar component video interface.
Schematic section for Mstar CVBS and VIF interfaces.
Schematic section detailing the Mstar audio and SIF interfaces.
Schematic section for the Mstar Common Interface (CI) connections.
Schematic section showing Mstar connections related to Transport Stream (TS).
Schematic diagram for Mstar HDMI interface 1 and 2 connections.
Schematic diagram for the second part of Mstar HDMI interface connections.
Schematic section detailing Mstar LVDS interface connections.
Second part of the Mstar LVDS interface schematic.
Schematic for Mstar DDR memory interface A.
Schematic for Mstar DDR memory interface B.
Schematic for Mstar DDR memory interface C.
Schematic for Mstar NAND flash and FRC interfaces.
Schematic diagram showing Mstar General Purpose Input/Output (GPIO) connections.
Schematic for Mstar USB ports and miscellaneous interfaces.
Part one of the Mstar power supply schematic.
Part two of the Mstar power supply schematic.
Part three of the Mstar power supply schematic.
Schematic for peripheral components like crystal oscillators and straps.
Schematic showing reset circuits and I2C communication interfaces.
Schematic for serial communication interfaces.
Schematic detailing the DDR3 SDRAM memory modules.
Schematic showing damping resistors for DDR3 memory interfaces.
More schematics for DDR3 damping resistors.
Additional schematic diagrams for DDR3 SDRAM.
Schematic illustrating series resistors for DDR3 memory.
Schematic showing resistors related to the EBUS interface.
Schematic for SPI flash memory components.
Schematic diagram for NAND flash memory components.
Schematic for the Ethernet PHY component.
Schematic showing the RJ45 Ethernet connector and its connections.
Schematic for the side USB connectors.
Schematic for the audio output to the TV.
Schematic for the headphone amplifier circuit.
Schematic for the optical audio output.
Schematic for the main audio digital amplifier.
Schematic for the main audio D-AMP outputs.
Schematic related to audio mute functionality.
Schematic for the SCART connector and its European standard signals.
Schematic for the front AV input connectors.
Schematic for the D-SUB PC input connector.
Schematic for European component video input.
Schematic for European TV output.
Schematic for AV Input 1 connections.
Schematic for AV Input 2 connections.
Schematic for AV Input 3 connections.
Schematic for LVDS connector pin assignments.
Continuation of LVDS connector schematic.
Schematic for backlight control and dimming functions.
Schematic related to a specific function, possibly transistors.
Schematic showing HDMI connector pinouts.
Schematic for HDMI 5V power supply lines.
Schematic for HDMI Hot Plug Detect (HPD) signal.
Second part of the HDMI Hot Plug Detect (HPD) schematic.
Schematic for HDMI Display Data Channel (DDC) communication.
Schematic related to the main power supply for TV.
Schematic for the HDCP key ROM memory.
Schematic for LED indicators and Infrared interface.
Schematic for 5V LEDs and key inputs.
Schematic for the TVM fan control circuit.
Schematic for the TV tuner module.
Schematic for the DVB-S/S2 tuner.
Schematic for the demodulator of DVB-T2/T/C signals.
Schematic for the demodulator of DVB-S2/S signals.
Schematic for DiSEqC control and LNB power supply.
Schematic related to tuner power supply.
Schematic showing resistors for the CI TS interface.
Schematic for CI card power and connector.
Schematic for the CI address buffer.
Schematic showing resistors for CI data lines.
Schematic for the CI control signal buffer.
Schematic for the CI TS output buffer.
Schematic for the 3.3V standby power supply.
Schematic for the 1.1V power supply circuit.
Schematic for the FRC power supply at 1.26V.
Schematic for the FRC power supply at 1.5V.
Schematic for the 3.3VD power supply.
Schematic for the 6V power supply circuit.
Schematic for the panel interface power connections.
Schematic detailing the power connector pin assignments.
Schematic related to Electromagnetic Compatibility (EMC) control.
Section describing the remote control functionality and buttons.
