Print this page
Service Mode
Initialization of Main PCB
Whenever replacing the Defective Main Board with new one, perform the Model ID installation.
< Models >
32/40/46TL838, 32/40/46TL868, 32/40RL838, 32/40RL858
Model ID Installation
< Preparation >
Copy the required Model ID file on USB according to the model.
The Model ID files are uploaded the CP-Protal (refer to SVI 01B201145).
< Procedure >
1. Turn power on and then unplug the AC power.
2. The USB reader is located on the left or light of the cabinet near the side control/jack assembly as shown figure1.
ADJUSTMENT
Model name Part# for Main Board Model ID
32TL838 75026920 32TL838_491840_WOAP.bin
40TL838 40TL838_491840_WOAP.bin
46TL838 46TL838_491840_WOAP.bin
32TL868 75026921 32TL868_491840_WOAP.bin
40TL868 40TL868_491840_WOAP.bin
46TL868 46TL868_491840_WOAP.bin
32RL838 75026922 32RL838_491840_WOAP.bin
40RL838 40RL838_491840_WOAP.bin
32RL858 75026923 32RL858_491840_WOAP.bin
40RL858 40RL858_491840_WOAP.bin
To Next Page
Loading...
