3. Insert "USB drive" containing the Model ID into the USB slot.
4. Plug the AC.
5. The installation of Model ID will be automatically commenced.
Note: while the installation of Model ID, no indication will appear.
6. After about 60 seconds, unplug the AC connector.
7. Remove the USB drive form USB slot of the TV.
8. To check the Model ID version, press the "Menu" button on the remote controller and go "SET UP" and "System information" in sequence.
9. Press the bottom on the remote controller in the sequence of "3", "5", "7" and "4".
10. Confirm if mode name is subject to the model in Self check menu as shown figure.2.
Figure.1
Figure.2
TOSHIBA WEB-ZEUS
>> terms and conditions >> privacy policy
Copyright © 1995-2011 TOSHIBA Corporation, All Rights Reserved.
To Next Page
Loading...
