85
Setting up your TV
Using HDMI® CEC
No Signal Power Down
The TV will automatically turn itself off after 15 minutes when no
signal is detected. You can change the setting to Off for the
following purposes:
v Low signal strength of analog channel (no signal detection)
v Only Audio L/R is connected to external input to listen to music
through the TV speakers.
To change the no signal power down setting:
1 From the Options menu, highlight Power Management, and
then press the ENTER button.
2 Highlight No Signal Power Down, and then press the ENTER
button.
3 Press the ▲/▼(arrow) buttons to highlight the item you want
to change, and press the ◄/►(arrow) buttons to select On or
Off.
v Default setting for this feature is On.
v A warning message will appear 1 minute before the TV turns off.
Using HDMI
®
CEC
This is a new feature that uses CEC technology and allows you to
control Toshiba HDMI
®
CEC compatible devices from the TV
remote via HDMI
®
connection (see “HDMI® CEC connection” on
page 29)
When Enable HDMI CEC Control in the HDMI CEC Control
Setup menu is set to On (see “Setting up HDMI® CEC” on page 87),
the HDMI
®
CEC functions described below will be enabled.
HDMI
®
CEC playback device (Blu-ray
TM
Player/DVD player, etc.)
control
With your TV’s remote control, or using the HDMI
®
CEC Player
Control menu, you can control the connected HDMI
®
CEC
playback device you are watching.
Available remote control key functions
Button: Description:
PLAY Begin playback
STOP Stop playback
PAUSE Pause the picture during play or record mode
SKIP Forward Skip Forward
To Next Page
Loading...
Need help?
Display
Audio
Power
Connectivity
Weight and Dimensions
