89
Setting up your TV
Displaying TV status information
vThe signal information banner will appear when this feature is set
to On and you watch an HDMI
®
input and press the INFO button.
The signal information will disappear after approximately 60
seconds.
vIf you press the INFO button when this feature is set to Off, only
the normal banner will appear.
Displaying TV status information
To display TV status information using the RECALL button:
v Press the RECALL button on the remote control.
The following information will be displayed (if applicable):
v Current input (ANT/CABLE, Video, etc.)
v If ANT/CABLE is the current input, either “CABLE” (for cable
TV) or “ANT” (for over-the-air broadcasts).
v Channel number (if in ANT/CABLE mode)
v Digital signal strength indicator (bar graph in lower right
corner of box; for digital signals only)
v Stereo, Mono, or SAP audio status (when in HDMI
®
input
mode, Dolby
®
Digital, or PCM)
v Video resolution
v Aspect ratio of incoming video signal (4:3 or 16:9)
v V-Chip rating status
v GameTimer (if set)
To close the Recall screen, press the RECALL button again.
To display TV status information using INFO, press the INFO
button.
The following additional information will display for digital
channels, if applicable:
v Title
v Duration
To Next Page
Loading...
