Programming Channel Memory (Continued)
Aft
lm-
CHANNEL •/A
/
.e o e__.e_,e__,e
I ' I '
MENU <1/1_/V/&
RECALL@ MUTE@ _R
e
Number
A/•
</,
MENU
After performing the CH PROGRAM function, you can add or erase
specific channels.
1
Select the channel you want to erase using the CHANNEL • or A
button, or select the channel you want to add using the Channel
Number buttons.
2
3
PressMENU repeatedly untilthe Setup
menu is displayed on the screen.
Press • or • until "ADD/ERASE" is
displayed in purple.
TWCA_LE: [TVi_BLE
C_ PROG,,_AM
ADOIERASE: [ADO]ERASE
FAV_ITE C_
TO SELECT ITEM PUSH V•
TOCONTR(X PUSH <
4 Press < or I_
To erase the channel
Press the button until "ERASE" is dis-
played in purple indicating that the
channel has been erased from the
memory.
IV .¢ABLE _'_Yi_ABLE
TO SELECT ITEM PUSH • •
TO CONTROL PUSH •
To add the channel
Press the button until "ADD" is displayed
in purple indicating that the channel has
been memorized.
5 Repeat steps 1 to 4 for other channels.
You have now completed the channel programming.
CABLE channel reference chart
Correspond-
ing CABLE
channel
Correspond-
ing CABLE
cha_nel _'_ .
A-8 5(A-7) 6(A-6) A B C ..................U V W AA BB..................XX YY ZZ AAA BBB 65 66
67 68 69..................92 93 94 A-5 A-4 A-3 A-2 A-1 100 101 102 ..................123 124 125
The above chart is typical of many cable system channel allocations. If in doubt, consult your cable company.
16
To Next Page
Loading...
