Toshiba CF32H40 - Connecting VCR with S-Video; S-Video Input Selection

Connecting a VCR with an S-Video Jack
If you connect a VCR with an S-video jack to the S-VIDEO jack on the back of the TV, you must also connect the audio
cables to the AUDIO jacks of the VIDEO 1 IN jacks on the back of the TV. The S-video cable only carries the video signal.
Audio signals are separate.
Antenna/Cable
lead-in
Antenna Antenna
input output VCR
,-oil
outputs
S-video
output
S-video cable (not supplied)
Audio cable (not supplied)
,'-V_
Back of TV
IN _=_lr OUT
VIDEO1 VIDEO2 ilWOEO
v,o_o®-eii®_
LIo;'
AUDIO • II AUIDI
I I
ANT
(75_)
@
1 Turn the TV and VCR ON.
2 Press the W/VIDEO button to select "VIDEO 1"
TV
VIDEO 1
VIDEO 2
TO SELECT PUSH TV/VIDEO
Notes:
• When the S-video cable is connected to the S-VIDEO IN
jack, the video cable (phono-type) should not be
connected.
• The S-VIDEO jack accepts SEPARATED Luminance/
Chrominance (Y-C) signals conforming to the NTSC
standard.
o
m
o
>
o_
J=
>
O)
t-
O
C
r,
o
L)
n-
>
"o
r,
m
._.q
ID
C
c
o -
3 Operate your VCR normally.
3_14