Toshiba D-R2SU - Operation Panel Door

1-1-5. RAM Drive
1. Peel off four tapes (1).
2. Disconnect two flexible cables (2).
3. Disconnect the connector (3).
4. Remove two screws (4) and acrylic board (5).
5. Remove four screws (6), then remove the RAM drive (7).
1-1-4. Operation Panel Door
1. Open the operation panel door (1).
2. Release two claws and unhinge the door (1).
Fig. 2-1-4
Front panel
Hinge
Claw
Claw
Hinge
Operation panel door (1)
Flexible cable (2)
Flexible
cable (2)
Connector (3)
Tapes (1)
Tape (1)
Acrylic
board (5)
Screws (6)
Screws (4)
RAM drive (7)
Connector
Claw
Flexible cable (2)
A
A
Remove the connector claw
in the direction indicated
by the arrows to release the
flexible cable.
Fig. 2-1-5