e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC
3 - 26
3.4.2 Adjustment of image density
The image density level is adjustable both at standard and toner saving modes.
< Adjustment Mode (05) >
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [INTERRUPT] button to store the value in memory. The equipment goes back to the
ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Turn the power OFF and then back ON to perform printing job.
(8) If the desired image density has not been attained, repeat step (2) to (7).
Toner mode
Item to be adjusted Remarks
GDI PS/PCL
672-0 to 4 676-0 to 4 Adjustment of image density When the value is decreased, text becomes
lighter.
Acceptable values: 0 to 63
Notes:
1. Set not to reverse the large and
small number of the setting value
corresponding to the sub code.
Ex.) When substituting the setting
value for 672-0 with A0, · · ·, 672-
4 with A4: A0 A1 A2 A3 A4
2. Remember that the image speci-
fications and life span of the
replacing parts may not meet the
standard when the setting value
is changed from the default value.
To Next Page
Loading...
