1.LOADING PAPER
Loading Paper on the Bypass Tray 23
LOADING PAPER
If paper cannot be fed, printing takes a long time after feeding or the quality is poor, turn over the paper and
place it again as shown in the figure or place fewer sheets.
The operating procedure for using the bypass tray differs depending on the paper size to be used. See the table below
for the operating procedure of each size.
Bypass printing stops when the paper placed on the bypass tray runs out during printing, even if the paper of the
same size is in any of the drawers. Printing restarts when paper is supplied to the bypass tray.
When you perform bypass copying, the [FUNCTION CLEAR] button on the control panel blinks to indicate that
copying has completed. Press this button to switch bypass copying to normal copying using the drawers.
(Even if you do not press the [FUNCTION CLEAR] button, the bypass copying mode will be cleared when the
automatic function clear mode kicks in after a specified period of time.)
Paper size Procedure
Standard size
Other than North
America: A3, A4, B4, B5
North America: LD, LT,
LG, ST-R
P.24 “Standard size paper on the bypass tray”
Other than the above
Envelope P.25 “Envelopes on the bypass tray”
Others (Non-standard sizes) P.27 “Non-standard paper on the bypass tray”
P.28 “Long custom size paper on the bypass tray”
To Next Page
Loading...
