1.LOADING PAPER
Loading Paper on the Bypass Tray 29
LOADING PAPER
When the paper is being fed into the equipment from the bypass tray
Be careful not to cut your fingers on the edge of paper when you hold it.
This could injure you.
Do not mix different sizes of paper.
Feed paper sheet by sheet from the bypass tray if you have set more than one copy in the number of copies setting.
Slightly curl the paper. Hold it gently as it is being fed into the equipment.
Make sure that the trailing edge of the paper will not be fed into the equipment while you are holding it.
Printing is done at 300 dpi if the custom paper size is longer than the maximum standard paper size: for example,
the maximum custom size is 305 x 1200 mm (12.01 x 47.24"). Even if 300 dpi or more is selected, it is changed to 300
dpi.
When the paper is coming out of the equipment
Be careful not to cut your fingers on the edge of paper when you hold it.
This could injure you.
Support the paper gently as it is coming out of the equipment.
Do not pull out the paper forcibly as it is exiting from the equipment.
To Next Page
Loading...
