1.LOADING PAPER
Loading Paper in Drawers 13
LOADING PAPER
6
Move the end guide to the trailing edge of the paper while pushing its lower part in the direction
of the arrows.
7
Check that there is no gap between the paper and the side guides, as well as the paper and the
end guide.
If the gap is too wide, it could cause paper misfeeding, or the paper size could not be correctly detected.
Between the paper and side guides (“A” in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less on one side, 1.0 mm (0.04") or less in total) However, if paper
misfeeding occurs, make a gap.
Between the paper and end guide (“B” in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less)
8
Change the paper size indicator if required.
9
Push the drawer straight into this equipment carefully until it comes to a stop.
The paper size is automatically detected.
To Next Page
Loading...
