Toshiba E-STUDIO 6528A - Page 8

8 CONTENTS
“File *.DRV on client DVD could not be found” is displayed. ................................................................................... 44
“Location does not contain information about your hardware” is displayed........................................................45
“This port is currently in use” is displayed. .............................................................................................................. 45
“Problem with the current printer setup” is displayed............................................................................................ 45
“Could not connect to the MFP device” is displayed. .............................................................................................. 45
The result of the fax job is not listed in the Send field of the [Log] tab................................................................... 45
Fax transmission has failed if a cover sheet is attached. ......................................................................................... 45
Log-in using client software has failed. .................................................................................................................... 45
Printing can be made even with an incorrect user name and password................................................................ 45
Chapter 8 QUESTIONS FOR NETWORK
Questions for Network......................................................................................................................... 48
The equipment cannot be located in the network................................................................................................... 48
The equipment cannot be located with Local Discovery......................................................................................... 49
The equipment does not respond to a ping command. .......................................................................................... 50
The touch panel has locked or a network shutdown has occurred after the LDAP search has been performed. 50
LDAP authentication takes a long time. ................................................................................................................... 51
SMB printing in a Windows operating system environment has failed. ................................................................. 51
Raw TCP or LPR print in a Windows operating system environment has failed..................................................... 52
IPP printing in a Windows operating system environment has failed. ................................................................... 52
Novell printing in a NetWare environment has failed.............................................................................................. 53
Printing in a Mac OS environment has failed. .......................................................................................................... 53
Printing in a UNIX/Linux environment has failed..................................................................................................... 54
Wireless LAN connection cannot be established. .................................................................................................... 55
Chapter 9 QUESTIONS FOR ERROR MESSAGES
Questions for Error Messages ............................................................................................................... 58
“Close *** cover” is displayed. .................................................................................................................................. 58
“Misfeed in ***” is displayed...................................................................................................................................... 58
“Install new *** toner cartridge” is displayed. ......................................................................................................... 58
“*** toner not recognized Check the toner cartridge” is displayed. ....................................................................... 58
“Check paper size setting on control panel for drawer N. Check the direction or size of the paper.”
is displayed................................................................................................................................................................. 58
“Wait (performing self-check)” is displayed. ............................................................................................................ 58
“Adjusting. Wait until printing resumed.” is displayed............................................................................................ 58
“Time for cleaning. Open the front cover and follow the guidance.” is displayed.................................................58
“Check the original and set it again.” is displayed................................................................................................... 59
“Change direction of original” is displayed.............................................................................................................. 59
“Change from this mode Count over, cannot store anymore.” is displayed ..........................................................59
“*** Ready(*** toner not recognized) Check the toner cartridge” is displayed. .................................................... 59
“Ready (saddle stitch tray full)” is displayed............................................................................................................ 59
“Ready (check saddle stitch stapler)” is displayed. ................................................................................................. 59
“Ready (Check Stapler)” is displayed. ...................................................................................................................... 59
“Ready (Check Stapler)” is displayed. ...................................................................................................................... 59
“Ready (hole punch dust bin is full)” is displayed.................................................................................................... 59
“Ready (finisher full)” is displayed............................................................................................................................ 60
“Ready (inner tray full)” is displayed. ....................................................................................................................... 60
“Cannot copy Check department counter” is displayed. ........................................................................................ 60
“Add paper” is displayed. .......................................................................................................................................... 60
“Call For Service” is displayed................................................................................................................................... 60
“Examine stapler in the saddle stitch unit.” is displayed. ....................................................................................... 60
“Check staple cartridge in the saddle stitch unit.” is displayed.............................................................................. 60
“Check staple cartridge” is displayed. ...................................................................................................................... 60
“Examine stapler.” is displayed. ............................................................................................................................... 60
“Saving Energy - Press ENERGY SAVER Button.” is displayed. ................................................................................ 60
“Change drawer to correct paper size” is displayed................................................................................................ 61
“Time for periodic maintenance” is displayed......................................................................................................... 61