1 BEFORE USING EQUIPMENT
10 BASIC Menu for the Copier Function
Equipment status indication area
The equipment status indication area shows the following information:
1. Receiving tray indication ( P. 3 6 )
This shows the tray to which copied paper exits.
2. [EXIT TRAY] button ( P.36)
This is for switching receiving (exit) trays.
3. Drawer buttons ( P.51)
These show the size of paper, amount of paper remaining in each drawer and the paper type set for the drawer. When
you want to use a particular drawer, press the corresponding button.
The button for the 2 trays of the Tandem Large Capacity Feeder shows the amount remaining in each tray.
If the paper size cannot be detected in this equipment, “ ” appears. In this case, check the following two items.
- Is unacceptable sized paper placed in the drawer?
P.11 “Acceptable copy paper”
- Is the gap between the paper and the side or end guides too big?
P.13 “Placing paper in drawers”
If the indication still remains, contact your service representative.
4. [BYPASS FEED] button ( P.3 7 )
When this button is pressed with paper set in the bypass tray, it will be selected as the paper source.
5. Paper type on the bypass tray ( P. 3 7 )
This shows the type of paper placed on the bypass tray with an icon.
2
1
3
5
4
To Next Page
Loading...
