3.BASIC COPY MODES
Selecting Finishing Mode 67
3 BASIC COPY MODES
Name of each part of the Finisher (optional)
MJ-1103
1. Upper receiving tray
2. Tray holder
3. Lower receiving tray
4. Sub-tray
5. Front cover
6. Hole Punch Unit MJ-6102
7. Stapling control section
MJ-1104
1. Upper receiving tray
2. Tray holder
3. Lower receiving tray
4. Sub-tray
5. Saddle stitch tray
6. Stopper
7. Front cover
8. Hole Punch Unit MJ-6102
9. Stapling control section
Using the tray holder
Open the tray holder when the length of the paper in the exit direction is
longer than A3 or LD size. The holder prevents paper, which has exited,
from falling. Return it to its original position after use.
For consistent paper exiting, make sure you return the tray holder to its
original position when using A3/LD size paper or smaller.
7
2
4
1
3
6
5
9
2
4
1
3
8
7
5
6
To Next Page
Loading...
