Description of Each Component
7
Left / Inner side
1. Platen sheet
Use this to hold the original on the original glass to scan it.
& P.40 “Regular Cleaning” in this manual
2. Original glass
Use this to copy three-dimensional originals, book-type
originals and special paper such as OHP lm or tracing
paper, as well as plain paper.
3. Touch panel
Use this to set and operate various types of functions such
as copying and faxing.
& P.10 “Touch panel” in this manual
4. Control panel
Use this to set and operate various types of functions such
as copying and faxing.
& P.8 “Control panel” in this manual
5. USB port
Use this connector when printing les stored in a USB
device or storing scanned data into the USB device.
6. Toner cartridge holder
7. Transfer/transport unit
Open it when a paper jam occurs.
8. Exit cover
Open it when releasing a paper jam in the paper exit
section.
9. Toner cartridge
& P.36 “Replacing Toner Cartridge” in this manual
10. Main power switch
Use this switch to turn the power of the equipment ON or
OFF.
& P.12 “Turning Power ON/OFF” in this manual
11. Scanning area
The data of originals transported from the Reversing
automatic document feeder are scanned here.
& P.40 “Regular Cleaning” in this manual
12. Original scale
Use this to check the size of an original placed on the
original glass.
10
12
11
9
8
7
6
4
3
2
1
5
To Next Page
Loading...
