Description of Each Component
This section describes the names and operations of the equipment, control panel and touch panel.
6
1.
Reversing automatic document feeder
The stack of originals is scanned one sheet at a time. Both
sides of the original can be scanned. A maximum of 100
sheets (80 g/m
2
or 20 lb. Bond) (or stack height 16 mm or
0.62”) can be placed in one go. (The maximum number of
sheets that can be set may vary depending on the media
type of the originals.)
2. Operator’s manual pocket (back side, optional,
KK-8560)
Keep the manual in this pocket.
3. Bypass tray
Use this to perform printing on special media types such
as OHP lm, etc.
4. Bypass cover
Open it when a paper jam occurs.
5. Paper feed cover
Open this cover when releasing paper misfed in the
drawer feeding area.
6. Paper size indicator
The size of the paper set in the drawer can be checked.
7. Drawer
A maximum of 550 sheets of plain paper can be placed in
one go.
8. Tandem large capacity feeder
A maximum of 3000 sheets (64 g/m
2
, 17 lb. Bond) or 2500
sheets (80 g/m
2
, 20 lb. Bond) of plain paper can be placed
in one go.
9. Front cover
Open it when a paper jam occurs in the transfer/transport
unit.
10. Toner cover
Open this cover when replacing the toner cartridge.
11. Network interface connector
Use this connector when connecting this equipment to a
network.
12. USB terminal (4-pin)
Use this terminal when connecting this equipment to a PC
with a commercially available USB cable.
Front / Right side
9
10
7
8
6
2
1
3
4
5
11
12
To Next Page
Loading...
