© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO163/166/203/206
ADJUSTMENT
3 - 23
3
3.3.6 Setting range correction (Adjustment of text peak)
The levels of the text peak for the range correction can be set at the following codes.
< Adjustment Mode (05) >
* The image changes slightly in text mode because it is treated as a simple binary format image.
<Procedure>
Procedure is same as that of P. 3-19 "3.3.1 Density adjustment".
3.3.7 Adjustment of smudged/faint text
The smudged/faint text can be set at the following codes.
< Adjustment Mode (05) >
Make a test copy and compare the image obtained with the current settings; if necessary, make adjust-
ment using the following procedure.
<Procedure>
Procedure is same as that of P. 3-19 "3.3.1 Density adjustment".
Original mode
Item to be adjusted Remarks
Text/Photo Photo Text
535 536 537 Text peak for range correction When the value is increased, text
(high image density part) becomes
lighter.
Acceptable values: 0 to 255
(Default: text/photo: 246, photo: 254,
text: 236)
Original mode
Item to be adjusted Remarks
Text/Photo
648 Adjustment of smudged/faint
spotted text
When the value increases, the faint text is improved.
When the value decreases, the smudged text is
improved.
Acceptable values: 0 to 4 (Default: 3)
Note:
Note:
Remember the image specifications and life
span of the replacing parts may not meet the
standard when the setting value is changed
from the default value.
06/04
To Next Page
Loading...
