Toshiba e-STUDIO166 - Page 135

© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO163/166/203/206
ADJUSTMENT
3 - 51
3
[B] Adjustment
(1) Close the ADF.
(2) Adjust it by turning the adjustment screws on the hinges.
• Adjust the height on the rear side by means of the screw on the hinge on the feed side of the
ADF.
Turn it clockwise Heightened
Turn it counterclockwiseLowered
Fig. 3-51
• Adjust the gap on the rear side by means of the screw on the hinge on the feed side of the
ADF.
Turn it clockwisLowered
Turn it counterclockwiseHeightened
Fig. 3-52