Toshiba e-STUDIO166 - Troubleshooting Moire and Lack of Sharpness

© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO163/166/203/206
TROUBLESHOOTING
5 - 23
5
3) Moire/lack of sharpness
Fig. 5-3
Moire
Lack of sharpness
Defective area Step Check items Prescription
Density reproduction 1 Check the reproduction of the image
density.
Adjust the density.
Parameter adjustment
value
2 Check the image processing param-
eters.
Check the adjustment value for
sharpness.
Printer section 3 Check test print image (07-113). When defects occur, perform the cor-
responding troubleshooting proce-
dure.
Defective area Step Check items Prescription
Density reproduction 1 Check the reproduction of the image
density.
Adjust the density.
Parameter adjustment
value
2 Check the image processing param-
eters.
Check the adjustment value for
sharpness.
Printer section 3 Check test print image (07-113). When defects occur, perform the cor-
responding troubleshooting proce-
dure.
4 Check the image processing param-
eters.
Check the encircled areas A and B in
the image, and change the sharp-
ness intensity in the sharpness
adjustment mode.
Feeding direction
AB