e-STUDIO163/166/203/206 © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 4
(5) Turn ON the power.
Downloading starts automatically and the processing status is displayed on Control panel.
Fig. 6-6
(6) After the update is completed properly, the LED (DRAWER and Original setting) on the control
panel blinks.
Fig. 6-7
When the update is not completed properly, the LED (Paper jam position) on the control panel
blinks. Turn OFF the power, and then check the following items. After confirming and clearing the
problems, restart updating from the beginning.
• Is the download jig connected properly?
• Is the updating data written to the download jig properly?
• Do the download jig and the equipment operate properly?
Fig. 6-8
(7) Turn OFF the power, remove the download jig and install the rear cover.
: ON : OFF
: ON : OFF
: ON
06/04
To Next Page
Loading...
