Toshiba e-STUDIO166 - List Print Mode (9 S)

© 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO163/166/203/206
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 11
2
2.2.4 List Print Mode (9S)
<Setting procedure>
101: FUNC (FUNC, 05/08) data list
102: System setting list
103: Memory dump list
Outputs a memory dump list of a specified size from a specified address.
Notes:
• Key in 6 digits for the address specification and 4 digits for the size specification.
• Key in using the digital keys as in the table below to enter the letters A to F.
E.g.)When outputting an 80 size dump list from the address 0x0000A0
Lists of the function setting, adjustment mode (05), setting mode (08), system setting, memory
dump, etc. can be output in this mode.
ROM versions of the System firmware and scanner (ADF) are printed on the top right of each list.
• T280SY0Wxxx: System firmware ROM version (The "xxx" part is displayed as "0xx" in
e-STUDIO163/203 and "1xx" in e-STUDIO166/206.)
• Vxxxx: Scanner ROM version (ADF ROM version)
Letter of alphabetABCDEF
Digital keys [*] [0] [*] [1] [*] [2] [*] [3] [*] [4] [*] [5]
Display Key-in order
Address specification (6 digits) 0000A0 [0] -> [0] -> [0] -> [0] -> [*] -> [0] -> [0]
Size specification (4digits) 0080 [0] -> [0] -> [8] -> [0]
[9][START]
[POWER]
[Digital keys]
List code
[START]
List starts
to be printed
[POWER]
OFF/ON
101:FUNC (FUNC,05/08) Data list
102:FUNCTION list
Address
specification
103:Memory dump list
(6 digits)
(4 digits)
[9][START]
[POWER]
[Digital keys] [Digital keys]
[Digital keys]
List code
[START]
[START]
[START]
[POWER]
OFF/ON
Size
specification
07/02