3.HOW TO USE EDITING FUNCTIONS
Applying Multiple Settings (JOB BUILD) 99
HOW TO USE EDITING FUNCTIONS
1
Press [JOB BUILD] on the EDIT menu.
2
Press [OK].
Job build is now set and the message below appears.
3
Place the first stack of originals, and then select settings.
Press [SETTINGS] on the touch panel to confirm the current settings.
If you want to change the settings, press the [FUNCTION CLEAR] button on the control panel, and then restart
the procedure from step 1.
When placing the original on the original glass, remember that 1 page is equal to 1 job.
When placing mixed-size originals on the ADF, see the following page:
P.29 “Copying mixed-size originals in one operation”
If you want to use a particular drawer, select it.
4
Press the [START] button on the control panel.
Scanning starts. When the scanning of all the originals is finished, the message below appears.
5
Place the next stack of originals, and then select the settings.
Repeat steps 4 and 5 until all the desired pages have been scanned.
If you do not change any settings, those for the last job will be applied.
To Next Page
Loading...
