Toshiba e-STUDIO211 - ADF (MR-2020) Adjustments; ADF Position Adjustment

3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO181/211
ADJUSTMENT
3 - 43
3.10 Adjustment of the ADF (MR-2020)
3.10.1 Adjustment of ADF Position
Perform this adjustment when the ADF is not installed in the correct position.
Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the ADF.
[A] Checking
(1) Open the ADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the ADF).
Fig. 3-37
(2) Remove the platen sheet.
Fig. 3-38
(3) Close the ADF and check if the positioning
pins fit the holes on the ADF.
Fig. 3-39