Toshiba e-STUDIO211 - Firmware Updating; Firmware Update Using Download Jig

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO181/211
FIRMWARE UPDATING
6 - 1
6. FIRMWARE UPDATING
When you want to update the firmware above or the equipment becomes inoperative status due to
some defectives of the firmware, updating the firmware is available by the following actions.
• Updating with the download jig
 P.6-1 "6.1 Firmware Updating with Download Jig"
Notes:
• Be sure to check the version of the firmware after it is updated.
• No error message appears even when the firmware for e-STUDIO163/166 is updated to e-
STUDIO181 by mistake. Make sure that the firmware to be updated corresponds to the
proper model, otherwise the copy speed of A4/B5 size paper feeding from the drawer
becomes 16 copies/min.
• No error message appears even when the firmware for e-STUDIO203/206 is updated to e-
STUDIO211 by mistake. Make sure that the firmware to be updated corresponds to the
proper model, otherwise the copy speed of A4/B5 size paper feeding from the drawer
becomes 20 copies/min.
6.1 Firmware Updating with Download Jig
In this equipment, it is feasible to update the firmware automatically by connecting the download jig
using the dedicated connector and turning ON the equipment.
Firmware Stored Download jig
System ROM System control PC board
(SYS board)
PWA-DWNLD-350-JIG1(16 MB)
or
PWA-DWNLD-350-JIG2(48 MB)
ADF ROM ADF control PC board
(MR-2017)
K-PWA-DLM-320
PWA-DWNLD-350-JIG
Fig. 6-1 Jig board: PWA-DWNLD-350-JIG2(48 MB) Fig. 6-2 Jig board: PWA-DWNLD-350-JIG1(16 MB)
Connector
(
for SYS board
connection
)
Connector
(
for ROM writer
adapter connection
)
Connector
(
for SYS board
connection
)
Connector
(
for ROM writer
adapter connection
)