e-STUDIO181/211 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 2
Important:
• The download jig (PWA-DWNLD-350-JIG) has two types having different ROM capacity.
• The download jig (PWA-DWNLD-350-JIG) is the jig in which the Flash ROM is mounted on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
P.6-6 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
Important:
Pay attention to the direction of the ROM.
Download jig ROM capacity
PWA-DWNLD-350-JIG2 (48 MB) 8 MB x 6
PWA-DWNLD-350-JIG1 (16 MB) 8 MB x 2
K-PWA-DLM-320
Fig. 6-3 Jig board: K-PWA-DLM-320
Connector Mark for ROM
installation direction
ROM
LED
To Next Page
Loading...
