5.[Administration] Tab Page
48 [Setup] Item List
Setting up LLTD Session
Enable this setting for confirming the device connection status or accessing the TopAccess. This setting also allows
you to discover the desired device over the local network and view device information such as location, IP address,
MAC address or profile on the Network Map under the Windows 7/Windows 8/Windows Server 2008/Windows Server
2012 environment.
5 Enable Authentication Trap Select whether to send SNMP Traps when this equipment is accessed using
SNMP from a different read community. [Enable] is set as the default.
6 Enable Alerts Trap Select whether to send SNMP Traps when an alert condition occurs. [Enable]
is set as the default.
7 IP Trap Address 1 to 10 Enter the IP address where the SNMP Traps will be sent. You can specify up to
10 addresses. Specify within the range from 0 0 0 0 to 255 255 255 255.
8 IPv6 Trap Address 1 to 10 Enter the IPv6 address where the SNMP Traps will be sent. You can specify up
to 10 addresses. Specify within the range from 0:0:0:0:0:0:0:0 to
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff.
9 IP Trap Community Enter the trap community name for the IP Traps. You can enter up to 31
alphanumerical characters, symbols, and spaces. “public” is set as the
default.
Item name Description
1 Enable LLTD Select whether the LLTD setting is enabled or disabled.
Enable — Enables the LLTD.
Disable — Disables the LLTD.
2 Device Name Enter a device name to be displayed on the Network Map.
You can enter up to 16 alphanumerical characters, symbols, and spaces.
Item name Description
To Next Page
Loading...
