Toshiba E-STUDIO2329A - Network Settings

5.[Administration] Tab Page
36 [Setup] Item List
 Network settings
You can configure the network settings such as TCP/IP, Filtering, IPv6, DNS Session, SMB Session, HTTP Network
Service, SMTP Client, POP3 Network Service, FTP Client, SNMP Network Service, and LLTD Session.
In the Network submenu page, click link or scroll the page to find the setting table, and click the button of the setting
to set the network settings.
In each sub window for network settings, click [Save], and click [OK] in the confirmation dialog box to save the
settings and close the sub window. Click [Cancel] to restore the current settings without saving the changes.
Changes of settings of TCP/IP, Filtering, and IPv6 will automatically restart the equipment.
 Setting up TCP/IP
You can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be configured to enable
TopAccess, Raw TCP printing, LPD printing, IPP printing, and Scan to Email.
 P.36 “Setting up TCP/IP”  P.44 “Setting up SMTP Client”
 P.39 “Setting up Filtering”  P.46 “Setting up POP3 Network Service”
 P.41 “Setting up IPv6”  P.46 “Setting up FTP Client”
 P.42 “Setting up DNS Session”  P.47 “Setting up SNMP Network Service”
 P.43 “Setting up SMB Session”  P.48 “Setting up LLTD Session”
 P.44 “Setting up HTTP Network Service”  P.49 “Setting up Wake Up Setting”
1
2
3
4
5
6
7
8
9