4
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
GENERAL OPERATION
4 - 3
4.2.3 Drawer feed copying (Upper drawer paper feeding)
1) Press the [START] button
→ “READY” changes to “COPYING”
→ Exposure lamp ON
→ Scan motor ON → carriages -1 and -2 move forward
→ Polygonal motor rotates in high speed
→ Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
2) Drawer paper feeding
→ Main charger, developer bias and discharge LED ON. Fans are rotated in high speed. Drawer
feed clutch ON.
- The pickup roller, feed roller, separation roller and transport roller start to rotate.
→ Paper reaches the 1st transport sensor
- The 1st transport sensor is turned ON.
→ Paper reaches the registration roller.
- The registration sensor is turned ON and aligning is performed.
→ Drawer feed clutch OFF after a certain period of time
3) After the carriage operation:
→ Registration clutch ON after a certain period of time paper is transported to the transfer area.
→ Copy counter operates
4) After the registration clutch is turned ON:
→ Transfer charger ON after a certain period of time
→ Copy counter operates
5) Completion of scanning
→ Scan motor OFF
→ Exposure lamp OFF
→ Registration clutch OFF (after the trailing edge of the paper passed the registration roller)
→ “READY (PRINTING)” is displayed
6) Paper exit
→ Exit sensor detects the trailing edge of the paper
→ Main charger, developer bias and discharge LED OFF
→ Polygonal motor, main motor and exit motor OFF
→ Drum, fuser unit and developer unit stop
→ Fans return to the ready rotation
→ “READY” is displayed and the equipment enters the ready mode
To Next Page
Loading...
