10
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
DRIVE SYSTEM
10 - 7
(8) Remove 3 screws. Take off the main motor
drive unit front bracket while removing the
timing belt, gear, pin and bushing.
Fig. 10-8
(9) Take off the gear and timing belt from the
main motor drive unit rear bracket.
Fig. 10-9
Note:
When assembling the main motor drive unit,
assemble it while the fixing screw is loos-
ened. Then hook the tension spring and
tighten the fixing screw of the tensioner.
Fig. 10-10
Bushing
Pulley
Pin
Bushing
Screw
Screw
Drive unit front bracket
Timing belt
Gear
Gear
1
2
Tension spring
Fixing screw
To Next Page
Loading...
