14
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
PAPER EXIT SECTION
14 - 7
[E] Exit roller
(1) Take off the paper exit unit.
( P.14-5 "[B] Paper exit unit").
(2) Remove 2 springs.
Fig. 14-9
(3) Remove the plate spring.
Fig. 14-10
(4) Remove 1 E-ring and 1 bearing on the front
side. Remove 1 E-ring, 1 gear and 1 bearing
on the rear side.
(5) Take off the exit roller.
Fig. 14-11
Spring
Spring
Plate spring
Bearing
Bearing
Exit roller
Gear
E-ring
E-ring
To Next Page
Loading...
