15
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0102)
15 - 13
[F] ADU clutch
[G] ADU motor / ADU drive unit
(1) Take off the ADU cover
( P.15-12 "[E] ADU cover").
(2) Remove 1 E-ring and disconnect 1 connec-
tor. Then take off the ADU clutch.
Note:
When installing the E-ring, make sure that
the latches of both ends of E-ring are on the
flat part of the shaft.
Fig. 15-18
(1) Take off the ADU clutch
( P.15-13 "[F] ADU clutch").
(2) Remove the spring.
Fig. 15-19
(3) Remove 1 screw and take off the ADU rear
latch.
Fig. 15-20
ADU clutch
Shaft
E-ring
Spring
ADU rear latch
To Next Page
Loading...
