e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 48
(3) Loosen 6 screws, remove 1 screw, and then
take off the LGC board cover.
Fig. 2-62
(4) Disconnect 12 connectors and release the
harness form 5 harness clamps.
Fig. 2-63
(5) Remove 4 screws, release 1 locking support,
and then take off the LGC board.
Fig. 2-64
LGC board cover
Harness clamp
LGC board
05/11
To Next Page
Loading...
