2
© 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/232/233/280/282/283
OUTLINE OF THE MACHINE
2 - 57
[D] MJ-1022 (Hanging finisher)
[D-1] When PFP/LCF is not installed
(8) Lift up the equipment and take off the LCF.
Fig. 2-87
(1) Turn the power OFF and unplug the power
cable.
(2) Take off the connector cover and disconnect
the connector.
Fig. 2-88
(3) Remove 2 screws and take off the safety
bracket on the rear side and the cover.
Fig. 2-89
Connector
Connector cover
Cover
Safety bracket
To Next Page
Loading...
