7.TopAccess
92 Functional Setups
Procedure for Multi Station Print (Only in One Equipment Unit)
When an attempt is made to use the Multi Station Print function only in one equipment unit, register only the MFP to
be used since no MFP connection is carried out.
Setup
Operation
Checking the Multi Station Print Enabler
The Multi Station Printer Enabler is required for the use of the Multi Station Print function. For details, contact your
service technician or representative.
The setting of the Multi Station Print Enabler in your MFP can be confirmed as below.
[User Functions -User-] > the [Admin] tab > [General] > [License Management]
If [Multi Station Print] is registered in [License Management], the Multi Station Print function can be used.
Operation Description Reference
1 Checking the Multi Station
Print Enabler
Check whether the Multi Station Print
Enabler can be used with your MFP.
P.92 “Checking the Multi Station
Print Enabler”
2 Enabling the Multi Station
Print function
Enable the Multi Station Print function. P.74 “Setting up Multi Station
Print”
3 Setting the MFP Register the MFP (this equipment)
which is being connected with
TopAccess.
P.74 “Setting up Multi Station
Print”
Operation Description Reference
1 Performing Multi Station
Print
Print a job from the registered MFP. Printing Guide “Printing from Another
MFP (Multi Station Print)”
To Next Page
Loading...
