Changing the Paper Size of the Drawer and Adding Paper
5. Push the arrow part (left side) to lock the size
selection lever.
6. Place paper in the drawer(s).
y Place paper face up.
y Fan the paper well before placing it in the drawer.
y Do not add paper above the line indicated on
the guide.
y Do not use creased, folded, wrinkled or damp sheets
of paper.
OTE: Make sure that a gap of approx. 0.02” (less than
.
7. Push the drawer straight into the copier until it comes
TI when
8. Change the size mark plate to match with the size of
N
0.04” in total) is left between the paper and the side guide
If there is no gap, this could cause paper misfeeding.
to a stop. Be sure to push the drawer fully in.
P: Be careful not to let your fingers be caught
closing the drawer. This could injure you.
paper that has been set.
Page 22
To Next Page
Loading...
