Toshiba E-studio3055c - Placing Paper

1
Placing Paper and Originals
This section explains how to set paper and originals. Incorrect setting causes image skews or paper misfeeds. Follow the
procedure below.
Placing Paper and Originals
15
1
Pull out the drawer.
2
Set the side guide to match the paper width.
3
After fanning the paper, place it face up.
4
Set the end guide to match the paper size.
5
Push in the drawer.
Be sure that the height of the stacked paper does not
exceed the MAX line indicated on the side guides.
Placing paper
Be careful not to catch your ngers when pushing the
drawer back.
This could injure you.
• For paper available for the equipment, see the following
page:
& P.70 “Specications of Equipment” in this manual
• Paper can be placed in the Paper Feed Pedestal and the
Additional Drawer Module following the procedure
above. For placing paper in the Large Capacity Feeder,
refer to the following guide:
& Copying Guide (PDF): “Chapter 1: BEFORE USING
EQUIPMENT” - “Placing Paper”