2.PRINTING FROM WINDOWS
Setting Up Print Options 41
2 PRINTING FROM WINDOWS
- Envelope 2 — Select this when printing on envelope 2.
- Envelope 3 — Select this when printing on envelope 3.
- Envelope 4 — Select this when printing on envelope 4.
- Plain (Back) — Select this when printing on the back side of plain paper.
- Recycled (Back) — Select this when printing on the back side of recycled paper.
- Thick1 (Back) — Select this when printing on the back side of thick 1 paper.
- Thick2 (Back) — Select this when printing on the back side of thick 2 paper.
- Thick3 (Back) — Select this when printing on the back side of thick 3 paper.
- Thick4 (Back) — Select this when printing on the back side of thick 4 paper.
- Special 1 (Back) — Select this when printing on the back side of special 1 paper.
- Special 2 (Back) — Select this when printing on the back side of special 2 paper.
- Special 3 (Back) — Select this when printing on the back side of special 3 paper.
- Thin (Back) — Select this when printing on the back side of thin paper.
- Envelope (Back) — Select this when printing on the back side of an envelope.
The applicable paper weight for each paper type differs depending on the model. For details of the
paper weight, refer to the corresponding Quick Start Guide / User’s Manual Setup Guide.
[Special 3], [Special 3 (Back)], and [Thin (Back)] are enabled only when the model below is used.
- e-STUDIO5055C Series
For paper available for [Special 1], [Special 2], [Special 3], [Special 4], [Special 5] and [Special 6],
contact your service technician.
When [A4 Tab] or [Letter Tab] is selected at the [Print Paper Size] box, [Tab] will be displayed and
you cannot change the paper type.
When [Envelope] is selected at the [Print Paper Size] box, only [Envelope], [Envelope] and
[Envelope (Back)], or [Envelope 1], [Envelope 2], [Envelope 3] and [Envelope 4] will be displayed
and you cannot select other paper types.
Setup items differ depending on the model.
For more information about the paper types that are available for this equipment, refer to the Quick
Start Guide / User’s Manual Setup Guide.
6) Destination
This selects the tray to which the print job is made to exit. The figure on the right indicates the destination
currently set with an arrow.
- Exit Tray — Select this to have paper exit to the exit tray.
- Upper Exit Tray — Select this to have paper exit to the upper exit tray.
- Job Separator Upper — Select this to route the upper exit tray of the Job Separator.
- Job Separator Lower — Select this to route the lower exit tray of the Job Separator.
- Side Exit Tray — Select this to route the output to the side exit tray of this equipment.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
- Saddle Tray — Select this to route the output to the saddle tray of the Saddle Stitch Finisher.
The selectable items differ depending on the model, the paper size, and the option configuration.
The destination is limited to [Saddle Tray] when you perform folding print or saddle stitch print with
the Saddle Stitch Finisher installed.
You can select the tray by directly clicking on the figure on the right.
Select [Tray 1] if you want to reduce the initialization period if the Finisher is installed.
To Next Page
Loading...
