Chapter 1 PREPARATIONS
16
Turning o
Follow the steps below. Check the following items before turning o the equipment.
• No jobs should be le in the print job list.
• The PRINT DATA lamp (blue) or the MEMORY RX lamp (green) should not be flashing.
(If the equipment is shut down while any of the above lamps are flashing, jobs in progress such as FAX
reception will be aborted.)
• No computer should access the equipment over a network, such as TopAccess.
If you press the [POWER] button while a job is running, a message is displayed asking if you want to delete the
current job and turn o the equipment.
Press the [POWER] button.
You can then select how to turn the equipment
o. If you press [Shutdown], the screen
disappears and the equipment is turned o aer
a short while.
When turning the equipment back on aer turning it o, wait for approximately 30 seconds.
To Next Page
Loading...
